Ram

Zdravim chlapaci,neviem ci viete o tomto probleme-http://www.youtube.com/watch?v=XXkqBgYshmU&feature=player_embedded :S
Riesili to aj na aprilia fore
www.apriliaforum.com/forums/showthread.p...light=subframe+bolts
www.apriliaforum.com/forums/showthread.p...light=subframe+bolts
tak ak ste o tom nevedeli,skontrolujte si tie styri matice pre istotu.
Dotahovaci moment ma byt 50NM,a doporucuju pouzit aj Loctite.
Ja som to skontroloval dnes,ale vsetko bolo ok.
Radsej skontrolovat ako skoncit so zlomenym ramom.

Ahoj, všim sem si toho hned jak sem koupil Mašinu, měl sem povolený ty horní a jeden spodní jak je zapuštěnej do rámu

A co konkretne na tom treba skontrolovat? Ci su nie tie skrutky prilis dotiahnute, alebo povolene? Ako by sa dalo tomu predist?

I dont think so....As long as you check those bolts and make sure they are tight (50NM)
I just re-torqued mine the other night. The top 2 felt like they may have loosened slightly since last time I checked them (lower 2 seemed fine). I removed all 4 nuts and applied some RED loctite this time.

This is really something that everybody should check!

Bill

If the bolts are not tight, all of the stresses will be concentrated in one area of the fixing hole, due to the side-forces that then result.

Z tohohle, jestli tomu dobře rozumim, píšou, že důležitý je mít ten šroub dotažený. A loctide tam dávají, aby se ty šrouby nepovolovaly. Alespoň tak tomu rozumim já